Data recording

Record the sensors you choose for a set time, then see them in a chart and export them.

Data recording reads up to 20 sensors of your choice for the time you set and keeps their values, so you can see how they changed: the engine warming up, the fuel trims on a climb, a temperature during a test. Each recording stays on the phone until you delete it.

  1. Choose the sensors

    On the Record tab, tap Add sensors and tick up to 20. The list shows what this car can read. The choice is kept per car, so next time it is already there.

  2. Use a profile

    The Profile field at the top fills the sensors for you. Ready for this car lists the profiles that fit this car, such as the filter regeneration, the turbo or the traction battery. If you change the sensors of a ready profile, save it as this car's version or tap Restore original. My profiles keeps your own. Profiles stay on the phone and go into the local backup.

  3. Choose when it starts

    Now starts with the car connected. On connect waits for the car's next connection, which captures a cold start. On trip waits for the car's next trip. A trip recorded by hand, without the adapter, does not start it.

  4. Set the duration and the interval

    Duration goes from 1 minute to 1 hour, or Until I stop; with On trip it can also end with the trip. These open durations stop on their own after 2 hours.

    Interval is how often each sensor is kept. Maximum keeps every reading, at the fastest rate set in the Performance settings; the line under it estimates the time between readings with your adapter.

  5. Record

    Tap Record, or Arm for the other two starts. While it records, the card shows the time, the number of samples and the latest value of each sensor. You can leave the screen or the app: the recording continues, and the home screen shows a strip that brings you back here.

    If the connection drops, the card says it is waiting for the car, and the recording continues when the car comes back.

  6. See and export

    The Recordings tab lists them by day; swipe one to the left to delete it. Open a recording to see every sensor in the chart: drag across it to read the values at any moment, and tap a sensor under the chart to hide or show it. The table below gives the minimum, average and maximum of each sensor.

    Export CSV creates a spreadsheet file with one column per sensor, in your units. On the free plan, the export shows a short video first. Record again brings back the same setup.


← All guidesIn the FAQ: Diagnostics →